知识卡片
力控制映射不等于完整力闭环
JᵀF可把目标末端作用力转为理想关节力矩,但接触刚度、摩擦、重力补偿和执行器误差仍影响实际力。若需要维持抛光等指定接触力,还需合适反馈与稳定性设计;几何映射本身不保证实测等于目标。
这张卡片看不懂?
这张卡片已通过人工审查,不再接受失败反馈。
已有反馈 · 0 条
还没有人提交反馈。
在整书笔记中的位置
- · 力
原书出处 · 1 处
- · 查看原书依据
Equation (4.5) is useful on a variety of different problems. The most typical application is force control—that is, the robot’s motors are actuated so as to apply a specified wrench on the environment. For example, one may want to use a robot for a polishing task in which it needs exert a vertical force of 5N on a table. In this case, the desired wrench
参考来源
- 位置:《Introduction to Autonomous Robots Mechanisms, Sensors, Actuators, and Algorithms (Nikolaus Correll, Bradley Hayes etc.)》第04章《力》(来源项目:a19c7933-4eda-4176-aebd-30fe7e1ad292;源文件:extracted/Introduction to Autonomous Robots Mechanisms, Sensors, Actuators, and Algorithms (Nikolaus Correll, Bradley Hayes etc.)/_epub-src/OEBPS/xhtml/chapter_4.xhtml)
- 结论依据:摘录中关于力控制映射不等于完整力闭环的定义、比较或条件支撑卡片;原书表述不严谨的范围已在覆盖记录逐项限定,不把案例结果外推为普遍结论。
- 原始内容:Equation (4.5) is useful on a variety of different problems. The most typical application is force control—that is, the robot’s motors are actuated so as to apply a specified wrench on the environment. For example, one may want to use a robot for a polishing task in which it needs exert a vertical force of 5N on a table. In this case, the desired wrench