← 返回刚才阅读的位置

知识卡片

普通读书笔记卡 · 9197.c · 生成模型:GPT-6

螺旋搜索用接触变化识别入孔

理解等级:中级

示例在接触面上作螺旋并穿插向下探测,结合轴向力、侧向力矩和高度判断找到轴或孔。探测可避免已进入后又横移破坏状态,但力矩变大也可能是卡滞,必须与位置及其他结果一起解释。

这张卡片看不懂?

已有反馈 · 0 条

    还没有人提交反馈。

    在整书笔记中的位置

    原书出处 · 1 处

    • · 查看原书依据

      Spiral insertion is best suited for hole-on-peg operations, and peg-in-hole operations with a peg diameter less than 1 cm. It is described for hole-on-peg assemblies in figure 14.4. The algorithm proceeds as follows: (a) Given a shaft end pose, the grasped part—for example, a gear with a center hole—is held vertically above the shaft by a preset distance. (b) The hand then moves down along

    参考来源

    - 位置:《Introduction to Autonomous Robots Mechanisms, Sensors, Actuators, and Algorithms (Nikolaus Correll, Bradley Hayes etc.)》第14章《操纵》(来源项目:a19c7933-4eda-4176-aebd-30fe7e1ad292;源文件:extracted/Introduction to Autonomous Robots Mechanisms, Sensors, Actuators, and Algorithms (Nikolaus Correll, Bradley Hayes etc.)/_epub-src/OEBPS/xhtml/chapter_14.xhtml) - 结论依据:摘录中关于螺旋搜索用接触变化识别入孔的定义、比较或条件支撑卡片;原书表述不严谨的范围已在覆盖记录逐项限定,不把案例结果外推为普遍结论。 - 原始内容:Spiral insertion is best suited for hole-on-peg operations, and peg-in-hole operations with a peg diameter less than 1 cm. It is described for hole-on-peg assemblies in figure 14.4. The algorithm proceeds as follows: (a) Given a shaft end pose, the grasped part—for example, a gear with a center hole—is held vertically above the shaft by a preset distance. (b) The hand then moves down along